Dishwasher Not Draining? 7 Common Causes and What to Check First
Opening the dishwasher to find a pool of dirty water in the bottom is one of the most common faults we see. The good news is that a large share of drainage problems come down to a blockage you can clear yourself in ten minutes. The rest need a technician, and knowing the difference saves you time and money.
Before you start: switch the dishwasher off at the wall, and have a towel and a shallow container ready. There may be more water than you expect.
1. A Blocked Filter
The filter sits in the base of the tub, usually under the lower spray arm. It catches food scraps, labels, broken glass and seeds. When it clogs, water cannot reach the drain pump. Twist it out, rinse it under the tap and scrub the mesh with a soft brush. This is the single most common cause, and it is worth cleaning the filter every month anyway.
2. A Kinked or Crushed Drain Hose
The drain hose runs from the back of the dishwasher to the sink waste. If the dishwasher has been pushed back hard into the cabinet, the hose can fold or flatten. Pull the dishwasher out gently and check that the hose follows a smooth path with a high loop before it drops to the waste connection.
3. A Blocked Sink Waste or Spigot
Most dishwashers drain into the spigot under the kitchen sink. If that spigot or the sink trap is blocked with grease, the dishwasher cannot push water out. If your sink is also draining slowly, the problem is probably the plumbing rather than the dishwasher. On new installs, also check that the blanking plug inside a new spigot was knocked out.
4. Debris in the Drain Pump
Under the filter on many models there is a small cover over the drain pump impeller. Fruit pits, glass and small bones can jam the impeller so it hums but does not turn. If you are comfortable doing so, with the power off, remove the cover and clear anything you find. If you are unsure, leave it to a technician.
5. A Failed Drain Pump
If everything is clear but the pump makes no sound at all during the drain stage, or it hums without moving water, the pump motor may have failed. This is a common repair and the part is usually replaceable on-site.
6. A Faulty Non-Return Valve
A small valve stops dirty water flowing back into the tub. If it sticks, water can return after the cycle finishes, so the dishwasher looks as if it did not drain at all.
7. Control or Sensor Faults
Less often, the dishwasher never actually calls for a drain because of a control board, pressure switch or water-level sensor fault. Many models show an error code in this case, which is worth writing down before you call.
Signs It Is More Than a Blockage
- The filter, hose and sink are clear but water still sits in the tub.
- You hear a hum, grinding or no sound at all during draining.
- An error code returns after you have cleaned everything.
- Water is leaking under the dishwasher as well as sitting inside it.
Our guide to dishwasher not draining repairs explains how we diagnose and fix these faults.
How to Stop It Happening Again
- Scrape plates into the bin before loading. You do not need to pre-rinse, but large scraps should go.
- Clean the filter monthly.
- Run the kitchen tap hot for a few seconds before starting the dishwasher, so the first fill is hot.
- Run an empty hot cycle with a dishwasher cleaner every one to two months.
Frequently Asked Questions
Is it safe to use my dishwasher if it is not draining?
No. Running more cycles adds more water and can cause an overflow or leak. Switch it off and clear the blockage or book a repair.
Why does my dishwasher drain only half way?
A partial blockage in the filter, hose or sink waste is the most common reason. A weak drain pump can also leave some water behind.
Can a blocked sink stop my dishwasher draining?
Yes. Most dishwashers drain through the sink waste. If the sink is slow to drain, fix that first.
Need a Technician?
If you have worked through the checks above and the drainage problem is still there, it is time for a proper diagnosis. Apex Home Appliance repairs all major dishwasher brands on-site across Greater Western Sydney. Call 0432 934 777 or book online, and see our dishwasher repair service for the areas we cover.