0432 934 777
Welcome to Apex Home Appliance Company

Dishwasher Won’t Start? A Step-by-Step Troubleshooting Guide

Fridge Repairs Lidcombe

Dishwasher Won’t Start? A Step-by-Step Troubleshooting Guide

A dishwasher that will not start, or one that lights up but never begins a cycle, is surprisingly often caused by something simple. Work through these checks in order before booking a repair.

Step 1: Check the Power

  • Is the dishwasher switched on at the wall? Dishwasher power points are often hidden in the cabinet next door or under the sink.
  • Check your switchboard for a tripped circuit breaker or safety switch.
  • If the safety switch trips again as soon as you reset it, do not keep resetting it. That points to an electrical fault in the dishwasher, and it should be checked by a technician.

Step 2: Check the Door

Dishwashers will not start unless the door is fully latched. Make sure nothing in the racks, such as a tall utensil or a large pot handle, is stopping it from closing. Close the door firmly and listen for a click. A broken door latch or door switch is a common reason for a dishwasher that powers up but will not run.

Step 3: Check Child Lock and Delay Start

Many dishwashers have a child lock that disables the buttons, and a delay-start setting that can be activated by accident. Check your manual for how to switch off the child lock, often by holding one or two buttons for a few seconds, and make sure delay start is not set.

Step 4: Check the Water Supply

Some dishwashers will not begin a cycle, or will stop with an error, if they cannot fill. Check the tap under the sink is fully on and the inlet hose is not kinked.

Step 5: Reset the Dishwasher

Switch off at the wall for five minutes, then turn it back on. This clears minor control glitches.

Step 6: Look for Error Codes

If there is an error code or a flashing light pattern, note it down. Our Bosch dishwasher error code guide covers the codes we see most often on Bosch, Siemens and Neff models.

Faults That Need a Technician

  • Failed door latch or switch: the dishwasher has power but the cycle never starts.
  • Control board or user-interface fault: buttons do not respond, or the display is blank.
  • Thermal fuse: a safety fuse can blow and cut power to the controls.
  • Inlet valve: the dishwasher tries to start but cannot fill.
  • Wash motor: the dishwasher fills but hums without washing.

Frequently Asked Questions

Why does my dishwasher have power but will not start?

The most common causes are a door that is not fully latched, the child lock being on, delay start being set, or a faulty door switch.

Why does my dishwasher keep tripping the power?

Repeated tripping usually means an electrical fault such as a heating element, pump or wiring problem. Stop using it and have it checked.

How do I reset my dishwasher?

Turn it off at the wall for five minutes. Some models also have a reset button combination, which your manual will show.

Need a Technician?

If you have worked through the checks above and the starting problem is still there, it is time for a proper diagnosis. Apex Home Appliance repairs all major dishwasher brands on-site across Greater Western Sydney. Call 0432 934 777 or book online, and see our dishwasher repair service for the areas we cover.