0432 934 777
Welcome to Apex Home Appliance Company

Dishwasher Not Cleaning Properly? Causes, Fixes and When to Call a Technician

Dishwasher Repairs Concord.

Dishwasher Not Cleaning Properly? Causes, Fixes and When to Call a Technician

A dishwasher that runs a full cycle but leaves food stuck to plates, grit in cups or a white film on glasses is frustrating, because it looks as though it is working. In most cases the cause is water not reaching the dishes with enough pressure or heat. Here is how to narrow it down.

Check the Simple Things First

Loading

Overloading or blocking the spray arms is the most common reason for poor results. Tall items in the lower basket can stop the upper arm turning, and large platters along the front can block detergent from reaching the load. Spin each spray arm by hand after loading to make sure it moves freely.

The Filter

A clogged filter recirculates dirty water over your dishes. Remove and rinse it, and get into the habit of cleaning it monthly.

Detergent

Old or clumped tablets do not dissolve properly. Store detergent somewhere dry and check the dispenser lid is opening during the cycle. If the tablet is still sitting in the dispenser at the end, the lid or its latch may be faulty.

Spray Arm Problems

Each spray arm has small holes that can block with seeds, glass or limescale. Remove the arms (most clip or unscrew), rinse them under the tap and clear the holes with a toothpick. Cracked arms or worn bearings stop the arm spinning and should be replaced.

Water Temperature

Dishwashers heat water, but they need to reach temperature to dissolve grease and activate detergent. If the heating element or thermostat has failed, plates come out greasy and cold, and the drying stage often stops working too. This is a repair for a technician.

Water Supply Issues

A partially blocked inlet hose filter or a faulty inlet valve means the dishwasher does not fill properly, so there is not enough water to wash with. If the dishwasher sounds as if it is running dry or the cycle seems unusually short, this is worth checking.

White Film or Cloudy Glasses

Cloudy residue is usually hard-water scale or detergent residue rather than dirt. Try a dishwasher cleaner, make sure rinse aid is topped up, and, if your model has a salt reservoir and water softener, check it is filled and set for your water. Etching that does not wipe off is permanent glass damage, often from soft water combined with too much detergent.

When It Is a Fault, Not a Habit

  • The spray arms do not turn even when nothing is blocking them.
  • Dishes are cold or greasy at the end of the cycle.
  • The detergent tablet does not dissolve or the dispenser does not open.
  • There is very little water in the tub during the wash.

These point to a wash pump, heater, inlet valve or dispenser fault. Our dishwasher not cleaning properly repair page explains what we test.

Frequently Asked Questions

Why are my dishes gritty after a wash?

Grit usually means dirty water is being recirculated because the filter is blocked, or food is being sprayed back on from a blocked spray arm.

Do I need to pre-rinse my dishes?

No, but you should scrape off large scraps. Modern detergents work best with some soil to act on.

Why are my glasses cloudy?

Usually hard-water scale or detergent residue. Rinse aid and a periodic dishwasher cleaner help. If the film will not wipe off, it may be permanent etching.

Need a Technician?

If you have worked through the checks above and the cleaning problem is still there, it is time for a proper diagnosis. Apex Home Appliance repairs all major dishwasher brands on-site across Greater Western Sydney. Call 0432 934 777 or book online, and see our dishwasher repair service for the areas we cover.